狠狠大日本亚洲香蕉亚洲,欧美激情15p,在线观**视频,国产福利一区二区三区视频在线,国产精品网站在线观看,亚洲精品天堂自在久久77,欧美一级特黄啪啪片免费看

 KP servo electric hydraulic...
 KP energy saving system
 KP60G General inverter
 KP90G elevator inverter
 KP200 controller
 KP80G controller
 KP-60G X cutting inverter
 KP-BR controller
 KP Special servo drive
 KP Permanent magnet servo
Asynchronous servo inverter
KP escalator controller
 Japan Sumitomo pump
 KP Lathe special inverter
Lathe Servo
Energy Japan
More>>  
 KP90G parameters
 KP60G parameters



Waste heat recovery energy-saving injection molding machine drying system
 


Introduction:
  It consists of heat recovery parts,transmission parts,control parts,injection molding machine barrel can be heat use,can be completely energy-saving drying barrel for drying and electricity consumption.
  The heat collecting cover,a hot air conveying system,automatic cooling system,hot air automatic compensation system,electric control system,including the structure of the device filter device.
  ①Gathering heat cover---The heat collecting barrel out walking.
  ②A(yíng)ir conveying system---The collected heat through the fan to the drying barrel,used as the drying of plastic raw materials.
  ③Automatic cooling system---When the collection of plastic material drying heat energy exceeds the normal temperature,the system will automatically work drying temperature,resulting in material drying temperature is normal.
  ④Hot air compensating system---When the drying temperature is not enough,can automatically compensate the recovery of hot,in order to make baked sizes reach normal.
  ⑤Filtering device---Filter material barrel blowing dust,keep the floor clean.

characteristics:

  Electricity:Heat energy recovery and utilization;using high efficient heat collecting technology;save electricity.
  Cooling:Reduce heat emission;using energy closed-loop control technology to reduce the temperature of a workshop.
  Environmental protection:Filtering recycling flow;temperature devices to keep workshop clean and efficient air filter.

Specifications:

Injection molding machine:HT80T    Desiccant capacity:50KG    Plastic:ABS 85Degree
  per hour
Install front
Install After
Energy saving
Energy saving ratio
Barrel

4.5Degree

2Degree

2.5Degree

55%
Drier
Monthly province electricity
2.5Degree*24hr.*30Day*0.85=1530(rmb)

Copyright 2018 KEPU GROUP. All Rights Reserved   
Address: KEPU Yinzhou industrial Zone, Yinzhou County, Ningbo, Zhejiang Province, China 315040    
Tel:+86 0574 8823 3677  Fax:+86 0574 8823 9359   E-mail:twz2005108@163.com